Yard Measure Kit

Fence Post Concrete Calculator

Calculate concrete bags and gravel. Start with fence runs and gates, or enter your post counts directly.

Count posts from runs and gates

Enter an open chain of straight runs in order, starting at one end. Each junction shares one corner post. For separate sections or a closed loop, enter post groups manually.

One per line: run number, distance from the start of that run (ft), opening width (ft). Place gates inside a run, with space at each end.

Applying the count creates new groups with example hole dimensions. Adjust each group to match your project.

Post counts and hole sizes

Enter separate groups when line, corner, or gate posts use different holes.

Bag yield and allowances

Replace the default yield with the value printed on your bag.

How the estimate works

For each round hole, subtract the cross-sectional area of the square post from the area of the hole. Multiply the result by the hole depth minus the gravel thickness. This assumes the post sits on top of a full-width gravel base. Use the actual measured post width. A nominal wood 4×4 often measures 3½ inches across.

Add the concrete volume for all groups, apply the allowance, divide by the yield per bag, then round up once. If you mix one hole at a time and discard leftover mix, your job may require more bags.

Formula for a round hole and square post

Concrete per hole (ft³) = [π × (hole diameter ÷ 2)² − post width²] × (hole depth − gravel thickness) ÷ 1,728. Enter all dimensions in inches.

Gravel per hole (yd³) = π × (hole diameter ÷ 2)² × gravel thickness ÷ 46,656. The base fills the full width of the hole.

Worked example: an L-shaped fence with one gate

  1. Enter two connected runs of 16 ft and 9 ft, with up to 8 ft between posts. Put a 4 ft gate 6 ft from the start of the first run. The fence spans on either side of that gate are each 6 ft, so neither needs an intermediate post. The 9 ft run needs one line post.
  2. The layout gives 6 posts: 2 ends, 1 corner, 2 gate posts and 1 line post. The two runs share the corner post.
  3. For this example, all posts are 3½ in wide. Use 10 in holes for the four non-gate posts and 12 in holes for the two gate posts. Each hole is 30 in deep with a 6 in gravel base. These are example dimensions for estimating quantities.
  4. The holes take 6.48 ft³ of concrete before the allowance. With 10% extra and a yield of 0.45 ft³ per 60 lb bag, buy 16 bags of concrete and 0.08 yd³ of gravel.

Concrete bags by bag weight and yield

Shopping list for the six-post example, including 10% extra concrete
Bag weightYield (ft³)Bags to buy
40 lb0.324
50 lb0.37520
60 lb0.4516
80 lb0.612

Yields are example values. Use the yield on your specific product label.

Should I round up per hole or for the whole project?

Round once across the project if you can share leftover mix between holes. The six-post example takes 16 bags that way. If you use whole bags at each hole and discard the excess, rounding each hole separately gives 20 bags with the same allowance and bag yield.

Can I estimate a closed fence or a gate at a corner?

Enter post counts manually for closed loops, separate sections or gates that share a corner or end post. Group posts by hole size and count each physical post once.

Use this for material quantities. Check the product label and local requirements before choosing hole dimensions and post spacing.